Transformer soldering iron with 220V to 24V overload protection for soldering the middle walls into the honeycomb frames

SKU: LE-3262
GTIN: 4250605406264
Category: Solder transformers
Manufacturers: Diverse Lieferanten

Trafolöter for tinned, galvanized and stainless steel wire. The beekeeper provides his frames with center walls. These are attached to a wire stretched into the honeycomb frame by soldering. This transformer enables safe soldering using a low protective voltage.

49,50 €

incl. VAT , plus (Standard Paketversand)

Manufacturers recommended retail price: 51,00 €

(Save 2.94%, i.e. 1,50 €)

Choose tax zone / country of delivery

Available immediately
Delivery time: 2 - 6 Workdays (DE - int. shipments may differ)

pce

Description
Reviews

Transformer soldering machine for soldering in center walls

Since the introduction of mobile construction in the beehive, beekeepers have had the option of fitting the honeycomb frames with beeswax plates, center walls. The cell pattern of the combs is pre-printed on these center walls. The middle walls allow the bees to build up a comb overnight if there is good honey flow. In natural hives this normally takes much longer. The most diverse and inventive methods are devised to attach these center walls. The most tried and tested is the tensioning of frame wire. This tensioning wire, now made of stainless steel, is heated by means of an electric current. The center walls placed on this honeycomb wire are heated at the contact points and sink in. It can be easily controlled that the wire is in the middle of the center walls. For soldering, place the center walls on the wires and press the poles (banana plugs) by hand onto one end of the frame wire.

-Suitable for tinned, galvanized and stainless steel wire up to a diameter of approx. 0.5 mm
-For soldering the center walls into the frames
-Mains voltage 220V
-Output side protection low voltage 24V
-Wattage 60 VA (W)
-The pole ends are well insulated and easy to hold in the hand.
Short-circuit proof